Viathan 2TB PRO M.2 PCIe Gen4 NVMe Internal SSD - Up to 7450MB/s

Prepare Tools

Step 1

You'll need a small screwdriver (usually Phillips or Torx) and an anti-static wrist strap or mat to prevent electrostatic discharge

Check SSD Compatibility

Step 2

Ensure that your laptop supports NVMe SSDs and has an available M.2 slot.

You can refer to the laptop's manual or specifications to confirm this.

Power Off and Disconnect

Step 3

Shut down your laptop completely and unplug it from the power source.

Remove the battery if possible.

Locate the M.2 Slot

Step 4

Depending on your laptop model, the M.2 slot may be located on the bottom of the laptop, underneath a panel, or under the keyboard.

Refer to your laptop's manual for the precise location.

Open the Laptop

Step 5

Remove the screws or clips securing the access panel or keyboard, if necessary.

Gently lift the panel or keyboard to expose the internal components.

Install the NVMe SSD

Step 6

Identify the M.2 slot, which is a small rectangular socket.

Align the notches on the SSD with the slot and insert it at a 30-degree angle. Apply gentle pressure until the SSD is fully seated in the slot.

Secure the SSD

Step 7

Once the SSD is properly inserted, use the screw(s) provided with the laptop or SSD to secure it in place.

Tighten the screw(s) carefully, but avoid overtightening.

Reassemble the Laptop

Step 8

Put the access panel or keyboard back in place, securing it with the screws or clips.

Make sure everything is aligned correctly.

Power On and Initialise the SSD

Step 9

Reconnect the power source and turn on your laptop. Enter the BIOS/UEFI settings and check if the SSD is detected.

If necessary, initialize the SSD and format it using the operating system's disk management tool.

Prepare Tools

Step 1

You'll need a small screwdriver (usually Phillips) and an anti-static wrist strap or mat to prevent electrostatic discharge.

Check Compatibility

Step 2

Ensure that your desktop PC has an available M.2 slot that supports NVMe SSDs. Refer to your motherboard's manual or specifications to confirm this.

Power Off and Disconnect

Step 3

Shut down your desktop PC completely and unplug it from the power source. Press the power button to discharge any remaining power.

Locate the M.2 Slot

Step 4

The M.2 slot on a desktop motherboard is usually located near the PCIe slots or near the CPU socket. Refer to your motherboard's manual for the exact location.

Remove the PCIe Slot Covers

Step 5

Some motherboards may have protective covers installed on the M.2 slots. Unscrew and remove any covers present.

Install the NVMe SSD

Step 6

Align the notches on the SSD with the slot on the motherboard. Insert the SSD at a 30-degree angle and apply gentle pressure until it is fully seated in the slot.

Secure the SSD

Step 7

Use the screw(s) provided with the motherboard or SSD to secure the NVMe SSD in place. Tighten the screw(s) carefully, but avoid overtightening.

Reassemble the Desktop PC

Step 8

Put the PCIe slot covers back in place, if applicable. Ensure all cables are properly connected and secure any panels or covers you removed earlier.

Power On and Initialize the SSD

Step 9

Reconnect the power source and turn on your desktop PC. Enter the BIOS/UEFI settings and check if the SSD is detected. If necessary, initialize the SSD and format it using the operating system's disk management tool.